Adventure Time Demon Blood Sword
An easy print to do as it was all in one colour, I managed to get this print done in 2 print runs with no supports needed as long as you place the parts sensibly in Simplify3d.
The print is in 12 pieces which snap together quite comfortably however I would recommend using superglue just to give it that extra strength.
The sword weighs 180 grams approx and is 32 centimeters in length, feels great to hold after an 8 hours to print.
Overall this print is sturdy but should only be a display piece and not used as a toy.
Slicing software: Simplify3D
Printer: Prusa i3 (clone)
Print time: 8 hours approx.
Filament: PLA – 1.75mm – Red by 3D Solutech Printing Filament
Heated Bed: No
Fan Speed: 50% first layer – 100% all other layers