3D Printers Tool Box Essentials

Chris Newton

Founder & Editor of Newton's Box. I am a 3D printing enthusiast who loves to tinker and design in my spare time with my FDM & SLA printers.

You may also like...

4 Responses

  1. jo sensai says:

    I recommend using hairspray on a heated glass bed at about 60 degrees instead of blue tape, guaranteed better results. 🙂

  2. Chris Newton says:

    After writing this post some people have told me that WD40 probably is not the best solution for lubricating your threaded rods.
    3-in-One multipurpose oil is safer for your 3D printer.

  3. If you need to cut glass plates for your printer, this cutter works much better for me than the cheap glass cutter I was using previously.

Leave a Reply